51 24... Notes on setting tailgate closing force
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2016 BMW 435i xDrive, 2016 BMW 435i, 2016 BMW 428i xDrive, 2016 BMW 428i, and 2015 BMW 435i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
- General information
For different reasons it can be necessary to change the closing force of the tension springs, e.g.:
- Frequent parking uphill or parking in two-level garages (tailgate does not remain in open position)
- Customer complaint of operating convenience when opening and closing the tailgate
- Retrofit/dismantling of accessories on tailgate (e.g. rear spoiler, warning triangle, etc.)
The closing force can be changed by reattaching the tension spring at the rear holder.
IMPORTANT: It is not permitted to change the attachment on the hinge. - Adjustment positions:
- Soft (factory setting without rear spoiler)
- Medium
- Hard (factory setting with rear spoiler)
- Adaptation of the closing force:
- Check the position of the tension springs on the left/right
NOTE: The left/right tension springs may be attached in different positions. Exception: Position (1) on one side and position (3) on the other side is not permissible. This causes tailgate inclination.- If possible, firstly reattach the right tension spring in the next higher/lower position
- Check the closing force
- If necessary, reattach the left tension spring in the next higher/lower position
- Check the closing force, repeat the process as required
Procedure for reattaching the tension spring: See 51 24 325 REMOVING AND INSTALLING/REPLACING LEFT TENSION SPRING FOR TAILGATE and 51 24 324 REMOVING AND INSTALLING/REPLACING RIGHT TENSION SPRING FOR TAILGATE .