33 32... Replacing left or right trailing arm bracket
Necessary preliminary tasks
- Remove TRAILING ARM WITH BRACKET
IMPORTANT:
When replacing trailing arm:
Replace self-tapping screw.
Before installing the trailing arm, tap a thread in the trailing arm with the new screw.
Replace self-tapping screw.
Before installing the trailing arm, tap a thread in the trailing arm with the new screw.
Release screw (1) and remove bracket (2).
Tightening torque 33 32 4AZ .
Installation:
Tighten down screw in NORMAL POSITION .
After installation
- Perform chassis alignment check. See 3200150 KDS CHASSIS/WHEEL ALIGNMENT CHECK WITH VEHICLE LOAD UP TO DESIGN POSITION or 3200155 KDS WHEEL ALIGNMENT CHECK WITH RIDE HEIGHT MEASUREMENT WITHOUT VEHICLE LOAD .