27 10 020 Installing Replacement Transfer Box (ATC 700)
WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Before and after replacement, execute the "Repair" service function with the BMW diagnosis system.
Recycling:
Catch and dispose of escaping transmission fluid. Observe country-specific waste-disposal regulations.
IMPORTANT:
After completing work, check transmission oil level and top up if necessary.
Release filler plug (1).
Check oil level.
Tightening torque 27 00 11AZ, see TRANSFER BOX IN GENERAL .
Pour in transmission oil up to lower edge of opening for filler plug (1).
Use only the approved transmission oil.
Release filler plug (1).
Check oil level.
Tightening torque 27 00 11AZ, see TRANSFER BOX IN GENERAL .
Pour in transmission oil up to lower edge of opening for filler plug (1).
Use only the approved transmission oil.
Failure to comply with this requirement will result in serious damage to the transfer box!
Necessary preliminary tasks:
- Drain transmission oil at oil drain plug
Tightening torque, 27 00 11AZ, see TRANSFER BOX IN GENERAL .
- Remove transfer box. See 27 10 010 Removing and Installing Transfer Box ATC 700 (Automatic Transmission)
Modify following parts:
- Covers and protective caps
- Drive shaft transportation lock
- Vent hose of transfer box