Remote Key Initialization (M61 204 04)
WARNING: This page is about the Cooper Base, Automatic CVT, which is a different variant/trim than selected.
Publication date: 2006-10-05Reference number: M61 204 04
Supersedes refnos: M61 09 06
REMOTE KEY INITIALIZATION
TECHNICAL SERVICE BULLETIN
Reference Number(s): SI M61 09 06, Date of Issue:
October 5, 2006
Superceded Bulletin(s): S.M. M61 204 04, Date of Issue:
September 2004
| MINI: | R50 (Cooper), R52 (Convertible), R53 (Cooper S) from 07/04 production |
| GROUP: | General Electrical Systems |
NOTE:
This Service Information bulletin supersedes S.M. M61 204 04 dated September 2004.
SUBJECT
Remote Key Initialization
SITUATION
Remote control bar codes are no longer supplied with new vehicles.
CAUSE
On vehicles produced 07/2004 and later, a new remote key initialization procedure is required.
PROCEDURE
Initialize remote control keys as follows:
- Close all doors.
- Switch the ignition switch to KL-R, switch back off within 5 seconds and remove the key.
- Within 30 seconds, press and hold the unlock button and at the same time, press and release the lock button (3) times. (Must be completed within 10 seconds).
- Release both buttons. The doors will lock/unlock to signal a successful initialization.
- If additional keys need to be initialized, repeat steps 3 - 4 within 30 seconds.
- Switching the ignition to KL-R completes the initialization.