LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2011 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1547 (Body Panel System - Front End Body Panels) >> General Procedures >> Hood Alignment

Hood Alignment

WARNING: This page is about a different car, the 2011 Lincoln MKT. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the hood.
  2. Loosen the LH and RH rear lower hinge-to-body bolt to the point that the hood will have slight movement.
  3. Loosen the LH and RH front lower hinge-to-body bolt to the point that the hood will have slight movement.
  4. Adjust the hood to align the hood to fender fit. For additional information, refer to BODY PANEL SYSTEM - BODY REPAIRS article.
  5. Carefully close the hood, maintaining the hood-to-fender fit and tighten the LH and RH rear lower hinge bolts.
    • Tighten to 12 Nm (106 lb-in).
  6. Carefully open the hood and tighten the LH and RH front lower hinge bolts.
    • Tighten to 12 Nm (106 lb-in).
    7. NOTE: The hood adjusting bumpers are located in the hood panel.
  7. Adjust the hood bumper so the hood panel fits flush to the fenders.
scientia non olet · About LEMON Manuals