Removal And Installation

WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: If a vehicle has been in a crash, inspect the restraints control module (RCM) and the impact sensor (if equipped) mounting areas for deformation. If damaged, restore the mounting areas to the original production configuration. A new RCM and sensors must be installed whether or not the air bags have deployed. Failure to follow these instructions may result in serious personal injury or death in a crash.

NOTE: The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition is ON.

NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.

NOTE: There are 2 front impact severity sensors, one located on each side of the hood latch, on the radiator core support.

Depower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering .
Remove the pin-type retainers and radiator opening cover assembly.
Remove the bolt from the horn and bracket assembly (RH only).
Disconnect the horn electrical connector, horn and bracket assembly (RH only).
Remove the front impact severity sensor bolts.
- To install, tighten to 12 Nm (106 lb-in).
Disconnect the electrical connector and front impact severity sensor.
To install, reverse the removal procedure.
Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering .