LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2011 >> Milan Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1431 (Seat System - Seats) >> Removal And Installation >> Memory Seat Position Sensor >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The memory recline position sensor is part of the power seat recliner and is not serviceable separately. To install a new power seat recliner, refer to Seat Recliner - Power .
  1. Remove the front seat. For additional information, refer to Seat - Front .
  2. Remove the Driver Seat Module (DSM) and shield.
    1. Remove the bolt.
    2. Remove the 2 nuts.
    3. Disconnect the electrical connectors.
    4. Remove the DSM and shield.
    3. Fig 1: Identifying Electrical Connector, DSM And Shield, Nut And Bolt
    GF0018572Courtesy of FORD MOTOR CO.
  3. Disconnect the seat track position sensor electrical connector.
    4. Fig 2: Locating Seat Track Position Sensor Electrical Connector
    GF0018573Courtesy of FORD MOTOR CO.
  4. Rotate the seat track position sensor counterclockwise and remove the sensor.
    5. Fig 3: Rotating Seat Track Position Sensor Counterclockwise
    GF0018574Courtesy of FORD MOTOR CO.
  5. To install, reverse the removal procedure.
    • After installation, operate the seat through the entire range of travel for each new sensor installed to reset the motor stop positions in the DSM.
scientia non olet · About LEMON Manuals