LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2010 >> Milan Base, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Electronically Controlled Continuously Variable Transmission (ECVT)) >> In-Vehicle Repair >> Transaxle Support Insulator >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. Remove the Air Cleaner (ACL) assembly. For additional information, refer to REMOVAL AND INSTALLATION .
  2. Install the Engine Support Bar and support the engine and transaxle.
    Fig 1: Identifying Engine Support Bar
    G06261966Courtesy of FORD MOTOR CO.
  3. Disconnect the hood ajar electrical connector.
    Fig 2: Locating Hood Ajar Electrical Connector
    G06275516Courtesy of FORD MOTOR CO.
  4. Remove the bolt and the nut and position aside the Battery Junction Box (BJB).
    • To install, tighten to 10 Nm (89 lb-in).
    Fig 3: Locating Battery Junction Box Nut
    G06275517Courtesy of FORD MOTOR CO.
  5. Remove the 5 nuts and remove the transaxle support insulator and the bracket.
    • To install, tighten to 90 Nm (66 lb-ft).
    Fig 4: Locating Transaxle Support Insulator & Bracket
    G06275518Courtesy of FORD MOTOR CO.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals