Knee Air Bag Module: Installation
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- Install 4 new J-nuts.
- Install the knee air bag module and 4 bolts.
- Tighten to 9 Nm (80 lb-in).
- Connect the knee air bag module electrical connector.
- Attach the wiring harness to the knee air bag module bracket.
- Install the lower steering column shroud.
- Install the steering column opening cover reinforcement and 4 bolts.
- Tighten to 3 Nm (27 lb-in).
- Install the steering column opening trim panel and 2 screws.
- Repower the SRS. For additional information, REFER to SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING in the General Procedures portion of this service information.