LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Sable Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1318 (Automatic Transmission External Controls) >> General Procedures >> Selector Lever Cable Adjustment

Selector Lever Cable Adjustment

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Place the selector lever in the D position.
  3. Lift the lock upward on the transmission selector cable lock and remove the cable from the selector lever.
    4. Fig 1: Removing Selector Lever Cable From Selector Lever
    GF0015704Courtesy of FORD MOTOR CO.
  4. Place the transmission manual control lever in the D position by rotating the manual lever clockwise to the extent of travel, then rotate counterclockwise 3 detents.
  5. Install the transmission selector lever cable on the selector lever and push the lock downward to lock the selector lever cable adjustment lock.
    6. Fig 2: Locking Selector Lever Cable Adjustment Lock
    GF0015705Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals