LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Sable Base, AWD >> Repair and Diagnosis >> Steering >> Power Steering >> Power Steering System >> Removal And Installation >> Power Steering Control Valve Actuator >> Installation

Power Steering Control Valve Actuator: Installation

  1. Holding the power steering pump with a suitable holding device, install the power steering control valve actuator.
    • Tighten to 16 Nm (142 lb-in).
  2. Position the power steering pump and install the 3 power steering pump bolts.
    • Tighten to 25 Nm (18 lb-ft).
  3. Connect the power steering control valve actuator electrical connector.
  4. Using the Power Steering Belt Installation Tool, install the power steering pump belt onto the power steering pump pulley.
    • Install the Power Steering Belt Installation Tool between the power steering pump belt and pulley and turn the crankshaft bolt clockwise.
    5. Fig 1: Positioning Power Steering Belt Around Special Tool (303-1252/2) & Power Steering Pulley
    GF0031435Courtesy of FORD MOTOR CO.
  5. Install the RH splash shield and the 7 pin-type retainers.
    6. Fig 2: Identifying Pin-Type Retainers
    GF0045923Courtesy of FORD MOTOR CO.
  6. Fill the power steering system. For additional information, refer to STEERING SYSTEM - GENERAL INFORMATION article.
scientia non olet · About LEMON Manuals