Section 1435 (Electronically Controlled Continuously Variable Transmission (ECVT)): Removal: Transaxle

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

To remove the transaxle, follow the engine removal procedure. For additional information, refer to REMOVAL . Before removing the engine and transaxle from the vehicle, remove the drain plug and drain the transmission fluid.
- To install, tighten to 40 Nm (30 lb-ft).
NOTE: Do not drain the oil when removing the engine to service the transaxle.

NOTE: Inspect the plug and washer for damage and install a new plug if necessary.

Fig 1: Locating Drain Plug
Courtesy of FORD MOTOR CO.