LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Sable Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1435 (Electronically Controlled Continuously Variable Transmission (ECVT)) >> In-Vehicle Repair >> Transaxle Support Insulator >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the Air Cleaner (ACL) assembly. For additional information, refer to REMOVAL AND INSTALLATION .
  2. Install the Engine Support Bar and support the engine and transaxle.
    Fig 1: Identifying Engine Support Bar
    G06261966Courtesy of FORD MOTOR CO.
  3. Disconnect the hood ajar electrical connector.
    Fig 2: Locating Hood Ajar Electrical Connector
    G06275516Courtesy of FORD MOTOR CO.
  4. Remove the bolt and the nut and position aside the Battery Junction Box (BJB).
    • To install, tighten to 10 Nm (89 lb-in).
    Fig 3: Locating Battery Junction Box Nut
    G06275517Courtesy of FORD MOTOR CO.
  5. Remove the 5 nuts and remove the transaxle support insulator and the bracket.
    • To install, tighten to 90 Nm (66 lb-ft).
    Fig 4: Locating Transaxle Support Insulator & Bracket
    G06275518Courtesy of FORD MOTOR CO.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals