LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Sable Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1224 (Power Steering System) >> Removal And Installation >> Power Steering Control Valve Actuator >> Installation

Power Steering Control Valve Actuator: Installation

WARNING: This page is about a different car, the 2008 Mercury Sable, 2008 Ford Taurus X, and 2008 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.
  1. Holding the power steering pump with a suitable holding device, install the power steering control valve actuator.
    • Tighten to 16 Nm (142 lb-in).
  2. Position the power steering pump and install the 3 power steering pump bolts.
    • Tighten to 25 Nm (18 lb-ft).
  3. Connect the power steering control valve actuator electrical connector.
  4. Using the Power Steering Belt Installation Tool, install the power steering pump belt onto the power steering pump pulley.
    • Install the Power Steering Belt Installation Tool between the power steering pump belt and pulley and turn the crankshaft bolt clockwise.
    5. Fig 1: Positioning Power Steering Belt Around Special Tool (303-1252/2) & Power Steering Pulley
    GF0031435Courtesy of FORD MOTOR CO.
  5. Install the RH splash shield and the 7 pin-type retainers.
    6. Fig 2: Identifying Pin-Type Retainers
    GF0045923Courtesy of FORD MOTOR CO.
  6. Fill the power steering system. For additional information, refer to STEERING SYSTEM - GENERAL INFORMATION article.
scientia non olet · About LEMON Manuals