Torca® Clamp

WARNING: This page is about a different car, the 2008 Mercury Sable, 2008 Ford Taurus X, and 2008 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.

Remove the nut from the Torca® clamp.
Grind the spot weld and the tac weld from the Torca® clamp and remove the clamp.
Clean the uneven surface area and position the Torca® clamp.

Fig 1: Torca(R) Clamp Tack Weld

Courtesy of FORD MOTOR CO.

NOTE: Make sure the clamp position is no more than 27.5 mm (1.08 in) or less than 25.5 mm (1 in) from the inlet of the resonator pipe.

Make sure the back of the slot is covered by the clamp and the button is fully seated inside the notch.

Fig 2: Clamp Position (With Specifications)

Courtesy of FORD MOTOR CO.

NOTE: Do not tighten the clamp until the exhaust system has been aligned.

Tighten the Torca® clamp.
- Tighten to 55 Nm (41 lb-ft).