LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Sable Base, AWD >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel System - General Information >> Diagnostic Tests >> Fuel System >> Pinpoint Test >> Pinpoint Test A: Slow to Fill >> Pinpoint Test A: Slow To Fill

Pinpoint Test A: Slow To Fill

  1. A1 CARRY OUT INSPECTION AND VERIFICATION 
    1. YES  : REPAIR or INSTALL new components to correct the concern.
    2. NO  : Go to  A2.
  2. A2 CHECK THE SYSTEM FOR ANY EVAP DTCs 
    • Connect the scan tool.
    • Check the system for any of the following EVAP DTCs: P0446, P0451, P0452, P0453, P0454, P1443, P1450, P1451 and P260F.
    • Are any of these DTCs present? 
    1. YES  : REFER to Introduction - Gasoline Engines article to diagnosis the EVAP system.
    2. NO  : Go to  A3.
  3. A3 MONITOR THE FUEL TANK PRESSURE (FTP) WHILE FILLING THE FUEL TANK 
    1. YES  : Go to  A5.
    2. NO  : Go to  A4.
  4. A4 MONITOR THE FTP WHILE FILLING THE FUEL TANK WITH THE EVAP SYSTEM DISCONNECTED 
    • Disconnect the fuel tank-to-EVAP canister quick connect coupling at the EVAP canister.
    • Monitor the FTP reference value while filling the fuel tank. Refer to Introduction - Gasoline Engines article.
    • Is FTP within specification? 
    1. YES  : INSPECT the EVAP system for blockage or restrictions. REPAIR the blockage or restriction. If the blockage or restriction cannot be repaired, INSTALL new EVAP system components.
    2. NO  : Go to  A5.
  5. A5 CHECK THE FUEL TANK FILLER PIPE ASSEMBLY FOR BLOCKAGE OR RESTRICTION 
    • Remove the fuel tank filler pipe assembly. Refer to FUEL TANK AND LINES article.
    • Inspect the fuel tank filler pipe and fuel tank filler pipe vent tube (if equipped) for a blockage or restriction.
    • Is the fuel tank filler pipe or fuel tank filler pipe vent tube (if equipped) blocked or restricted? 
    1. YES  : If possible, REPAIR the blockage or restriction. If the blockage or restriction cannot be repaired, INSTALL a new fuel tank filler pipe or fuel tank filler pipe vent tube.
    2. NO  : Go to  A6.
  6. A6 CHECK THE FUEL TANK INLET CHECK VALVE 
    • Inspect the fuel tank inlet check valve for restriction or sticking.
    • Is the fuel tank inlet check valve restricted or sticking? 
    1. YES  : If possible, REPAIR the restrictions. If the restriction cannot be repaired, INSTALL a new fuel tank. REFER to FUEL TANK AND LINES article.
    2. NO  : Taurus X federal emissions vehicles, go to  A7. All others, INSTALL a new fuel tank. REFER to FUEL TANK AND LINES article.
  7. A7 CHECK TO MAKE SURE THAT THE FUEL LEVEL VENT VALVE IS FUNCTIONING CORRECTLY 
      NOTE: The fuel level vent valve is part of the fuel pump (FP) module on the Taurus X federal emission vehicles.
    • Remove the FP module. Refer to FUEL TANK AND LINES article.
    • Inspect the fuel level vent valve for foreign material at the bottom drain hole.
    • Invert the FP module. Watch for a movement and a click noise.
    • Was a movement/click noise witnessed? 
    1. YES  : Fuel level vent valve is OK. Retest the system for normal operation.
    2. NO  : INSTALL a new FP module. REFER to FUEL TANK AND LINES article.