LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2009 >> Mountaineer 4.0 E, RWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission External Controls >> Removal And Installation >> Selector Lever >> Installation

Selector Lever: Installation

NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place and the selector lever cable end is snapped onto the ball stud. Press the selector lever cable into the selector lever cable bracket and listen for the selector lever cable to click in place. Pull back on the selector lever cable to make sure that it is locked into the selector lever cable bracket. Also make sure that the selector lever cable end is correctly installed onto the ball stud. Pull back on the selector lever cable end to make sure that the selector lever cable end is correctly installed.
  1. Install the selector lever housing.
    • Tighten to 9 Nm (80 lb-in).
    2. Fig 1: Locating Selector Lever Housing Nuts
    GF0027531Courtesy of FORD MOTOR CO.
  2. Connect the wiring harness to the selector lever housing.
    3. Fig 2: Locating Selector Lever Housing Wiring Harness
    GF0027530Courtesy of FORD MOTOR CO.
  3. Connect the selector lever housing electrical connector.
    4. Fig 3: Locating Selector Lever Housing Electrical Connector
    GF0027529Courtesy of FORD MOTOR CO.
  4. Install the selector lever cable onto the selector lever housing.
    5. Fig 4: Locating Selector Lever Cable From Selector Lever Housing
    GF0027523Courtesy of FORD MOTOR CO.
  5. Connect the selector lever cable onto the selector lever.
    6. Fig 5: Locating Selector Lever Cable From Selector Lever
    GF0027522Courtesy of FORD MOTOR CO.
  6. Install the front floor console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE article.
scientia non olet · About LEMON Manuals