Throttle Position (TP) Sensor: Installation

All vehicles 

CAUTION: Do not reuse the throttle position (TP) sensor and screws. A new TP sensor and screws must be installed. Failure to follow this instruction may result in poor engine performance.
CAUTION: Do not use a high-speed driver to install the new screws or damage to the throttle position (TP) sensor may occur.
NOTE: When installing the new TP sensor, make sure that the radial locator tab on the TP sensor is aligned with the radial locator hole on the throttle body.
1. Position the new TP sensor and install the 2 new screws.
   • Tighten to 3 Nm (27 lb-in).
2. Connect the TP sensor electrical connector.

Vehicles equipped with a 4.6L (3V) engine 

3. Install a new O-ring seal, position the heated PCV fitting and install the bolts.
4. Install the ACL outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING article.