LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2007 >> Mountaineer 4.6 8, AWD >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Electronic Engine Controls >> Removal And Installation >> Powertrain Control Module (PCM) >> Installation

Powertrain Control Module (PCM): Installation

All vehicles 

  1. Install the PCM and bolts.
    • Tighten to 10 Nm (89 lb-in).
  2. Connect the PCM electrical connectors.
  3. Position the wiring harness and the A/C tube bracket(s) and install the nut(s). Connect the RH front wheel speed sensor electrical connector.
    • Tighten to 7 Nm (62 lb-in).

    4. Vehicles equipped with a 4.6L (3V) engine 

  4. Install the air cleaner. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING .

    5. All vehicles 

  5. Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation procedure. For additional information, refer to MODULE CONFIGURATION .
  6. Reprogram the passive anti-theft system (PATS). Carry out the Parameter Reset procedure. For additional information, refer to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
scientia non olet · About LEMON Manuals