LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2007 >> Monterey >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> In-Vehicle Servicing >> Transaxle Support Insulator >> Removal And Installation

Removal And Installation

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Support the transmission with a suitable jack.
  3. Remove the bolts and the anti-roll bracket.
    4. Fig 1: Locating Engine Roll Restrictor Bracket Bolts
    GF0033043Courtesy of FORD MOTOR CO.
  4. Remove the rear transaxle support nut.
    5. Fig 2: Locating Rear Transaxle Support Nut
    GF0033431Courtesy of FORD MOTOR CO.
  5. Remove the transaxle support bolt.
    • To install, tighten to 90 Nm (66 lb-ft).
    6. Fig 3: Locating Transaxle Support Insulator Retaining Bolts And Nut
    GF0033424Courtesy of FORD MOTOR CO.
  6. Remove the transaxle support.
  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals