LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2007 >> Monterey >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> In-Vehicle Servicing >> Output Shaft Speed (OSS) Sensor >> Installation

Output Shaft Speed (OSS) Sensor: Installation

  1. Install the OSS sensor.
    2. Fig 1: Output Speed Shaft Speed (OSS) Sensor
    GF0020133Courtesy of FORD MOTOR CO.
  2. Install the OSS cover.
    1. Install the cover.
    2. Install the bolt.
      • Tighten to 11 Nm (8 lb-ft).
    3. Install the connector.
    3. Fig 2: Identifying OSS Cover & Connector
    GF0033427Courtesy of FORD MOTOR CO.
  3. Connect the OSS connector.
    4. Fig 3: Output Speed Shaft Speed (OSS) Sensor Connector
    GF0020131Courtesy of FORD MOTOR CO.
  4. Install the heat shield.
    5. Fig 4: Locating Heat Shield
    GF0033426Courtesy of FORD MOTOR CO.
  5. Install the catalytic converter. For additional information, refer to EXHAUST SYSTEM article.
scientia non olet · About LEMON Manuals