LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2007 >> Montego Base, AWD >> Repair and Diagnosis (Single Page) >> Engine Performance >> Fuel Delivery >> Fuel Charging And Controls >> Removal And Installation >> Fuel Pump Driver Module (FPDM) >> Removal And Installation

Removal And Installation

All vehicles 

  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.

    2. Five Hundred 

  2. Remove the rear seat cushion and the rear corner backrest. For additional information, refer to SEATING article.

    3. Freestyle 

  3. Remove the C-pillar trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.

    4. All vehicles 

  4. Disconnect the fuel pump driver module (FPDM) electrical connector.
  5. Remove the 2 nuts and the FPDM.
    • To install, tighten to 5 Nm (44 lb-in).
  6. To install reverse the removal procedure.
scientia non olet · About LEMON Manuals