LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2007 >> Milan Premier, 3.0 1, AWD >> Repair and Diagnosis >> Body & Frame >> Seats >> Seating >> Removal And Installation >> Heated Seat Module >> Removal And Installation

Removal And Installation

NOTE: The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
  1. Remove the front passenger seat. For additional information, refer to Seat - Front .
  2. Remove the heated seat module from the cushion electrical bracket.
    • Disconnect the heated seat module electrical connector.
    • Remove the rivet and heated seat module.
  3. To install, reverse the removal procedure.
  4. Install the front passenger seat and repower the SRS. Do not prove out the SRS at this time.  For additional information, refer to Seat - Front .
  5. Carry out the Occupant Classification Sensor (OCS) System Zero Seat Weight Test. For additional information, refer to the General Procedures portion of SUPPLEMENTAL RESTRAINT SYSTEM .
scientia non olet · About LEMON Manuals