LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2006 >> Montego Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 249 (Engine System-General Information) >> Diagnosis And Testing >> Engine >> Component Tests >> Oil Pressure Test

Oil Pressure Test

WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING: If equipped with fire suppression system, depower the system. For important safety warnings and procedures, refer to FIRE SUPPRESSION SYSTEM .
  1. Disconnect and remove the oil pressure sensor from the engine.
  2. Connect the Oil Pressure Gauge to the oil pressure sender oil galley port.
  3. Run the engine until normal operating temperature is reached.
  4. Run the engine at the specified rpm and record the gauge reading.
  5. The oil pressure should be within specifications; refer to the SPECIFICATIONS in the ENGINE article.
  6. If the pressure is not within specification, check the following possible sources:
    • Insufficient oil
    • Oil leakage
    • Worn or damaged oil pump
    • Oil pump screen cover and tube
    • Excessive main bearing clearance
    • Excessive connecting rod bearing clearance
    7. WARNING: If equipped with fire suppression system, repower the system. For important safety warnings and procedures, refer to FIRE SUPPRESSION SYSTEM .
  7. If equipped with fire suppression system, repower the system.
scientia non olet · About LEMON Manuals