LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2005 >> Monterey >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> In-Vehicle Repair >> Transaxle Support Insulator >> Removal and Installation

Removal and Installation

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Support the transmission with a suitable jack.
  3. Remove the bolts and the anti-roll bracket.
    Fig 1: Removing Anti-Roll Bracket
    G04004757Courtesy of FORD MOTOR CO.
  4. Remove the rear transaxle support nut.
    Fig 2: Removing Rear Transaxle Support Nut
    G04004758Courtesy of FORD MOTOR CO.
  5. Remove the transaxle support bolt.
    • To install, tighten to 90 Nm (66 lb-ft).
    Fig 3: Removing Transaxle Support Bolt
    G04004703Courtesy of FORD MOTOR CO.
  6. Remove the transaxle support.
  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals