LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2005 >> Monterey >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Electronic Engine Control System >> Removal And Installation >> Throttle Position (TP) Sensor >> Removal and Installation

Removal and Installation

  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Disconnect the throttle position (TP) sensor electrical connector.
  3. Detach the harness retainer from the stud bolt.
  4. Remove the 2 TP sensor bolts and the TP sensor.
    • To install, tighten to 7 Nm (62 lb-in).
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals