LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2005 >> Grand Marquis Ultimate Edition >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> In-Vehicle Repair >> Digital Transmission Range (TR) Sensor >> Installation

Digital Transmission Range (TR) Sensor: Installation

  1. Install the digital TR sensor and loosely install the bolts.
    Fig 1: Installing Digital TR Sensor
    G04016696Courtesy of FORD MOTOR CO.
    2. NOTE: Manual shift lever shaft must be in the neutral position.
    Fig 2: Aligning Digital TR Sensor Slots Using Special Tool
    G03888628Courtesy of FORD MOTOR CO.
  2. Using the special tool, align the digital TR sensor slots. The tool is designed to fit snugly.
    3. CAUTION: Tightening one screw before tightening the other may cause the sensor to bind or become damaged.
    Fig 3: Tightening Screws
    G04016623Courtesy of FORD MOTOR CO.
  3. Tighten the screws in an alternating sequence.
  4. With the manual lever in overdrive, connect the shift lever control cable.
    Fig 4: Connecting Shift Lever Control Cable
    G04016714Courtesy of FORD MOTOR CO.
  5. Connect the digital TR sensor electrical connector.
    Fig 5: Connecting Digital TR Sensor Electrical Connector
    G04016694Courtesy of FORD MOTOR CO.
    6. WARNING: If equipped with fire suppression system, repower the system. For important safety warnings and procedures, refer to FIRE SUPPRESSION SYSTEM .
  6. If equipped with fire suppression system, repower the system.
scientia non olet · About LEMON Manuals