LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2002 >> Villager Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 1552 (Information System And Entertainment System) >> Removal And Installation >> Audio Digital Signal Processing (DSP) Module >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: This procedure applies to Fusion/Milan with Sony® sound and MKZ with THX® sound only. For all other amplifiers, refer to the appropriate procedure(s).
  1. Upload the audio DSP  module configuration information to the scan tool. For additional information, refer to PROGRAMMABLE MODULE INSTALLATION (PMI) .
    NOTE: Module configuration is required when a new audio Digital Signal Processing (DSP) module is being installed.
  2. Remove the 4 pushpins and the RH luggage compartment trim panel.
  3. Disconnect the audio DSP  module electrical connectors.
  4. Remove the 3 bolts and the audio DSP  module.
    • To install, tighten to 9 Nm (80 lb-in).
  5. To install, reverse the removal procedure.
    • Download the configuration information to the audio DSP  module. For additional information, refer to PMI  in MODULE CONFIGURATION .
scientia non olet · About LEMON Manuals