Remote Transmitter
NOTE:
Once programming mode has been entered and remote transmitter button is pressed for first time, all previously stored remote transmitter codes will be erased. All remote transmitters to be used with this system must be programmed at same time (maximum of 4 remote transmitters).
- To enter programming mode, cycle ignition switch from OFF to ON position 4 times within a 3 second period. Turn ignition switch to OFF position. central locking module will stay in learning mode for 20 seconds indicated by continually illuminated anti-theft LED in instrument panel.
- Press any button on remote transmitter. When a signal is accepted by central locking module from remote transmitter, anti-theft LED will flash.
- To program additional remote transmitters, repeat step 2 with a 2 second delay after anti-theft LED flashes.
- To exit learning mode, turn ignition switch to ON position. System will exit learning mode after 20 seconds if central locking module does not receive a remote transmitter signal.
- Test programmed remote transmitters, by performing all functions of each remote transmitter.