LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2000 >> Cougar 2.5 L, Standard >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Ignition System >> Camshaft Position Sensor (CMP) >> Removal & Installation (3.0L VIN U & 2)

Removal & Installation (3.0L VIN U & 2)

  1. CMP sensor is located on top of CMP synchronizer assembly. Disconnect negative battery cable. Remove the accelerator cable shield. Disconnect accelerator cable, speed control actuator cable and throttle return spring from throttle body lever. Remove 2 bolts retaining accelerator cable bracket and position aside.
  2. Loosen the clamp and disconnect the hose. Detach the spark plug wire retainer. Detach the wiring harness from the intake manifold support. Release the fuel charging wiring harness from the valve cover studs. Position the wiring harness away from the camshaft position sensor.
  3. Disconnect CMP sensor harness connector. Remove CMP sensor mounting bolts and CMP sensor. To install, reverse removal procedure. Tighten CMP sensor bolts to specification. See TORQUE SPECIFICATIONS . If CMP synchronizer removal and installation is necessary, see CMP SYNCHRONIZER .
scientia non olet · About LEMON Manuals