LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 1995 >> Villager LS >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul - 3.0L >> Ignition System >> Ignition Wires >> Removal

Ignition Wires: Removal

    CAUTION: Do not pull on the ignition wire as it may separate from the connector inside the boot.
    Fig 1: Removing Spark Plug
    G00490053Courtesy of FORD MOTOR CO.
  1. When removing ignition wires from spark plugs (12405), use Spark Plug Wire Remover T74P-6666-A. Grasp and twist the ignition wire spark plug boot back and forth on the spark plug insulator to free the boot.
    2. CAUTION: Do not pull on the ignition wire as it may separate from the connector inside the boot.
    Fig 2: Squeezing Locking Tabs
    G00490054Courtesy of FORD MOTOR CO.
  2. Disconnect the ignition wire from the ignition coil by squeezing the locking tabs and twisting while pulling upward.
  3. Open ignition wire separators and remove ignition wire.
scientia non olet · About LEMON Manuals