LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 1994 >> Tracer LTS, Automatic >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Ignition System >> Crankshaft Position Sensor >> Removal & Installation (3.8L & 4.6L)

Removal & Installation (3.8L & 4.6L)

  1. Disconnect negative battery cable. Remove serpentine drive belt. Raise and support vehicle. Disconnect sensor connectors. On 4.6L, discharge A/C system using approved refrigerant recovery/recycling equipment.
  2. Remove A/C compressor. On all models, remove sensor bolt and sensor. To install, reverse removal procedure. Tighten sensor bolt to specification. See TORQUE SPECIFICATIONS (V6) or TORQUE SPECIFICATIONS (V8). Evacuate and recharge A/C system.
scientia non olet · About LEMON Manuals