LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 1994 >> Capri Base, Standard >> Repair and Diagnosis >> Transmission >> Manual Trans >> Servicing - M/T >> Lubrication >> Checking Fluid Level

Checking Fluid Level

  1. Place vehicle on level surface. Slide protective boot up speedometer cable. Disconnect speedometer cable from drive gear at transaxle. Remove speedometer drive gear from transaxle. Carefully remove "O" ring from gear sleeve and wipe sleeve clean.
  2. Use marks on gear sleeve to confirm fluid level. Full/low mark is just above lower drive gear. Add fluid, as needed, through speedometer driven gear hole.
  3. Inspect "O" ring. Reinstall or replace as needed. Install speedometer driven gear. Tighten mounting bolt to 69-104 INCH lbs. (7.8-12 Nm).
scientia non olet · About LEMON Manuals