Outside Handle Cable: Installation
WARNING: This page is about a different car, the 2004 Dodge Grand Caravan, 2004 Dodge Caravan, and 2004 Chrysler Town & Country. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For power sliding door procedures refer to POWER SLIDING DOOR
.
- Match the replacement cable up against the old cable to verify the correct part.
- Position the outside handle cable on the side door.
- Connect the outside handle cable on the handle assembly. Hook the swedged cable end on the handle link and gently push the cable sleeve retainer in the handle bracket.NOTE: The outside handle cable is marked with red tape. It must be attached to the latch at the lowest point. This is marked with a "R" on the latch.
- Connect the outside handle cable on the latch assembly. Hook the swedged cable end on the latch link and gently push the cable sleeve retainer in the latch bracket.
- Trace the outside handle cable along its routing path and install on its retaining clips and position foam insulators. Use previously made schematic as a guide or remove the opposite side door trim panel and use that door as a guide.CAUTION: Be certain replacement cable is routed and retained correctly and foam insulators are properly positioned.
- Place the watershield into position and press securely to adhesive making sure to properly route wiring and linkages.
- Install the appropriate side door trim panel on the vehicle. (Refer to TRIM PANEL )
- Install stop bumper (Refer to STOP BUMPER ).
- Connect the negative battery cable.