LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 1993 >> Villager LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 401 (Door System - Sliding) >> Latch/Lock Assembly >> Removal

Latch/Lock Assembly: Removal

WARNING: This page is about a different car, the 2004 Dodge Grand Caravan, 2004 Dodge Caravan, and 2004 Chrysler Town & Country. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For power sliding door procedures refer to POWER SLIDING DOOR .
  1. Remove sliding door trim panel. (Refer to TRIM PANEL  )
  2. Remove sliding door stop bumper. (Refer to TRIM PANEL  )
  3. Peel watershield away from adhesive around perimeter of inner door panel.
  4. Disengage external cable from latch/lock assembly (Fig 1 ).
    Fig 1: Identifying Sliding Door Latch/Lock Assembly
    G03585889Courtesy of DAIMLERCHRYSLER CORP.
  5. Remove foam block.
  6. Remove inside door handle assembly (Refer to INSIDE LATCH HANDLE  ).
  7. Disengage inside cable from latch/lock assembly.
  8. Disengage link from bellcrank.
  9. Disengage hold open latch cable from lower hinge.
  10. Remove bolts attaching latch/lock control to sliding door (Fig 2 ).
    Fig 2: Identifying Removing Sliding Door Latch/Lock Assembly
    G03585890Courtesy of DAIMLERCHRYSLER CORP.
  11. If equipped, lower latch and disconnect wire connector from power door lock motor.
  12. Remove latch/lock from door.
scientia non olet · About LEMON Manuals