LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 1993 >> Villager LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 401 (Door System - Sliding) >> Inside Latch Handle >> Installation

Inside Latch Handle: Installation

WARNING: This page is about a different car, the 2004 Dodge Grand Caravan, 2004 Dodge Caravan, and 2004 Chrysler Town & Country. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place inside latch handle in position on vehicle.
  2. Engage cable end into latch handle.
  3. Engage cable casing end into release handle.
  4. Install push pin fastener to hold cable into release handle.
  5. Engage cable end into release handle mechanism.
  6. Engage clip to hold cable end into release handle mechanism.
  7. Place latch handle in position on sliding door.
  8. Install screw to hold top of inside release handle to sliding door.
  9. Install screws to hold bottom of inside latch handle to sliding door.
  10. Verify sliding door operation. Adjust as necessary. (Refer to ADJUSTMENTS  )
  11. Install sliding door trim panel. (Refer to TRIM PANEL  ).
scientia non olet · About LEMON Manuals