Inside Handle Cable: Installation

WARNING: This page is about a different car, the 2004 Dodge Grand Caravan, 2004 Dodge Caravan, and 2004 Chrysler Town & Country. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For power sliding door procedures refer to POWER SLIDING DOOR .

Match the replacement cable up against the old cable to verify the correct part.
Position the inside handle cable on the side door.
Connect the inside handle cable on the handle assembly. Hook the swedged cable end on the handle link and gently push the cable sleeve retainer in the handle bracket.
Install the inside handle assembly on the side door. (Refer to INSIDE LATCH HANDLE )
NOTE: The inside handle cable is marked with blue tape and must be attached to the latch at the center (just above the lower cable). This position is marked with a "B" on the latch.
Connect the inside handle cable on the latch assembly. Hook the swedged cable end on the latch link and gently push the cable sleeve retainer in the latch bracket.
Trace the inside handle cable along its routing path and install on its retaining clips and position foam insulators. Use previously made schematic as a guide or remove the opposite side door trim panel and use that door as a guide.
CAUTION: Be certain replacement cable is routed and retained correctly and foam insulators are properly positioned.
Install the latch assembly. Refer to the POWER SLIDING DOOR .
Place the watershield into position and press securely to adhesive making sure to properly route wiring and linkages.
Install the appropriate side door trim panel on the vehicle. (Refer to TRIM PANEL )
Connect the negative battery cable.