LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 1993 >> Villager LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 401 (Door System - Sliding) >> Hold Open Latch Cable >> Installation

Hold Open Latch Cable: Installation

WARNING: This page is about a different car, the 2004 Dodge Grand Caravan, 2004 Dodge Caravan, and 2004 Chrysler Town & Country. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For power sliding door procedures refer to POWER SLIDING DOOR .
  1. Match the replacement cable up against the old cable to verify the correct part.
  2. Position the hold open latch cable on the side door.
    NOTE: The hold open latch cable is marked with white tape. It must be attached to the upper most cable attachment at the latch. This position is marked with a "W" on the latch.
  3. Connect the hold open latch cable on the hold open latch assembly. Hook the swedged cable end on the latch link and gently push the cable sleeve retainer in the latch bracket.
  4. Install the hold open latch on the side door. (Refer to HOLD OPEN LATCH  )
  5. Connect the hold open latch cable on the latch assembly. Hook the swedged cable end on the latch link and gently push the cable sleeve retainer in the latch bracket.
  6. Trace the outside handle cable along its routing path and install on its retaining clips and position foam insulators. Use previously made schematic as a guide or remove the opposite side door trim panel and use that door as a guide.
    CAUTION: Be certain replacement cable is routed and retained correctly and foam insulators are properly positioned.
  7. Install the latch assembly, (Refer to LATCH/LOCK ASSEMBLY  )
  8. Place the watershield into position and press securely to adhesive making sure to properly route wiring and linkages.
  9. Install the appropriate side door trim panel on the vehicle. (Refer to TRIM PANEL  )
  10. Connect the negative battery cable.
scientia non olet · About LEMON Manuals