LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 1993 >> Villager LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 318 (Controls) >> Evaporator Temperature Sensor >> Installation

Evaporator Temperature Sensor: Installation

WARNING: This page is about a different car, the 2004 Dodge Sprinter. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the probe of the evaporator temperature sensor between the fins of the A/C evaporator.
    NOTE: The probe must not go into the same hole (in the A/C evaporator) that the probe was removed from.
  2. Install the wire harness connector to the evaporator temperature sensor.
  3. Install the air bezels to the instrument panel.
  4. Install the electrical connections.
  5. Install the instrument panel top section (Refer to INSTALLATION ).
  6. Install the A/C-heater control (Refer to INSTALLATION  ).
  7. Install the center section of the instrument panel.
  8. Install the speaker (Refer to INSTALLATION and ).
  9. Install the cover above the air nozzle on the passenger side.
  10. Install the passenger side airbag.
  11. Install the instrument cluster (Refer to INSTALLATION ).
  12. Install the cover to the instrument cluster.
  13. Install glove compartment.
  14. Install the radio (Refer to INSTALLATION ).
  15. Reconnect the negative battery cable.
scientia non olet · About LEMON Manuals