LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 1993 >> Villager LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 318 (Controls) >> A/C Pressure Transducer >> Installation

A/C Pressure Transducer: Installation

WARNING: This page is about a different car, the 2004 Dodge Sprinter. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate a new O-ring seal with clean refrigerant oil and install it on the A/C pressure transducer.
  2. Using an open end wrench, install and tighten the A/C pressure transducer into the fitting on the liquid line. Tighten the transducer to 12 N.m (106 in. lbs.).
  3. Reconnect the wire harness connector to the transducer.
  4. Reconnect the battery negative cable.
  5. Evacuate the refrigerant system (Refer to REFRIGERANT SYSTEM EVACUATE ).
  6. Charge the refrigerant system (Refer to REFRIGERANT SYSTEM CHARGE ).
scientia non olet · About LEMON Manuals