LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 1993 >> Tracer LTS, Standard >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Ignition System >> Distributor >> Removal & Installation (Except Probe 2.5L)

Removal & Installation (Except Probe 2.5L)

  1. Remove high tension lead and distributor cap. Rotate crankshaft in direction of normal rotation until piston No. 1 is at TDC of compression stroke. Disconnect negative battery cable.
  2. Ensure timing marks are aligned. Disconnect distributor wiring from harness. Mark distributor rotor and housing position for installation reference. Remove distributor hold-down bolt(s) and clamp. Some engines may be equipped with a security-type distributor hold-down bolt.
  3. If necessary, use Distributor Hold-Down Wrench (T82L-12270-A) to remove bolt. Remove distributor. Inspect distributor "O" ring and replace if necessary. To install, reverse removal procedure. Set base ignition timing. See ADJUSTMENTS article in the ENGINE PERFORMANCE Section.
scientia non olet · About LEMON Manuals