Crankshaft Position Sensor: Installation

Position sensor assembly on bracket. Install 2 sensor screws. Tighten screws to specification. See TORQUE SPECIFICATIONS. Ensure sensor is not overtightened. Route sensor wiring harness, and install connector. To complete installation, reverse removal procedure.

1. Route sensor wiring harness through belt cover. Install sensor assembly on mounting pad, and loosely install retaining screws. DO NOT tighten screws at this time.
2. Set clearance between crankshaft sensor and vane on crankshaft pulley to .03" (.8 mm). Tighten screws to specification. See TORQUE SPECIFICATIONS. Install lower timing belt cover. Install crankshaft pulley, and tighten bolt to specification. To complete installation, reverse removal procedure.

1. Position sensor assembly on bracket. Install 2 sensor screws, but DO NOT tighten. Install Crankshaft Sensor Gauge (T89P-6316-AH) to outside surface of one vane of shutter.
   NOTE: Gauge is magnetic and will conform to shape of vane.
2. Push sensor housing inward to contact gauge. Tighten bolts to specification. See TORQUE SPECIFICATIONS. Ensure sensor is not overtightened. Overtightening can damage crankshaft sensor.
3. Rotate crankshaft by hand to position shutter vane with gauge outside of air gap. Remove magnetic gauge. To complete installation, reverse removal procedure.