Window Regulator: Installation
- With glass in full-up position, install window regulator through access hole in door inner panel.
- Position regulator base plate to door inner panel and install four rivets.
- Install regulator equalizer bracket to regulator and loose assemble with two nut and washer assemblies.
- Install regulator glass bracket drive channel to glass and secure with two nut and washer assemblies. Tighten nut and washer assemblies to 9-14 N-m (7-10 lb-ft).
- Connect electric motor wiring.
- Lower door glass approximately 75mm (3 inches) from full up position.
- With door open, place hands on each side of glass and pull glass fully into door glass run assembly at B-pillar.
- Apply a downward pressure on the equalizer bracket and tighten two nuts and washer assemblies. Tighten to 9-14 N. m (7-10 Ft. Lbs.).
- Cycle door glass to ensure proper operation.
- Install door trim panel and watershield. See DOOR TRIM .