LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 1992 >> Cougar XR7 >> Repair and Diagnosis >> Body & Frame >> Power Windows >> Removal & Installation >> Motor >> Installation

Removal & Installation: Motor: Installation

  1. Position the motor and drive to the regulator and install the three screws snug--not tight.
  2. Connect the motor wires at the connector and cycle the glass to ensure gear engagement. After the gears are engaged, tighten the three motor and drive retaining screws to 5.6-9.6 N. m (50-84 INCH Lbs.).
  3. Install the door trim panel and watershield. See DOOR TRIM  .
  4. Connect battery ground cable.
    5. NOTE: Appropriate plug buttons may be installed to cover the exposed hole at the trim panel edge, if necessary.
  5. Check the drain holes at the bottom of the doors to ensure that each is open to prevent water buildup over the motor.
scientia non olet · About LEMON Manuals