Carburetor - Carter YFA 1-Bbl: Overhaul: Reassembly

NOTE: Use new gaskets. Make sure that new gaskets fit correctly and that all holes and slots are punched through and correctly located.

To reassemble carburetor, reverse disassembly procedures and note the following:

If throttle valve was removed, make sure notch in throttle valve is aligned with idle port in body flange. Make sure throttle plate does not bind or stick. Restake or peen throttle plate screws.
Make sure vacuum passage in accelerator pump housing is aligned with vacuum passage in main body.
Make sure bowl vent rod engages forked actuating lever when air horn is installed.