LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 1980 >> Bobcat Base, Standard Trans >> Repair and Diagnosis >> Steering >> Steering Column >> Steering Column Switches >> Removal & Installation >> Dimmer Switch >> Installation

Dimmer Switch: Installation

  1. Firmly push rod into switch. Compress switch until two 0.093" drill shanks can be inserted into alignment holes.
  2. Reposition upper end of wash/wipe switch, this can be done by feel. With a light rearward pressure on switch, install 2 screws and remove 2 drill bits.


  1. Align switch mounting holes with holes on column and install screws. Install dimmer switch lever by aligning key-way in switch with key-way in lever.
  2. Push lever into switch to full engagement. Install electrical connections and trim shroud.


  1. Position switch on steering column and loosely install bolts. Install electrical connections. Insert 3/32" drill through locating hole securing dimmer switch to connector body.
  2. Slide dimmer switch so that it firmly contacts actuator arm and tighten bolts.
scientia non olet · About LEMON Manuals