Remove/Install Upper Front CROSSMEMBER For Hood Catch With Radiator Unit - Ar88.00-D-2303-01TSC

	Risk of injury  caused by scraping or cutting body parts on sharp vehicle parts	Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels.	AS00.00-Z-0017-01A
	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A

Model 907 with engine 274 

Fig 1: Clip Remover (452 589 01 63 00)

1. Release and disconnect electrical connector (2) from horn (3).
2. Remove screw (10) and remove horn (3).
3. Remove electrical wiring harness from the left cover (9).
4. Unclip covers (9) with the clip remover and remove.
5. Remove screws/bolts (5) .
6. Unhook hood cable (6) from upper front crossmember with radiator unit (1) and position outside the working area.
7. Release and disconnect electrical connector (8) from the coolant expansion reservoir (7).
8. Engine 274 in model 907 with code HH4 (THERMOTRONIC automatic climate control) or code HH9 (semi-automatically regulated air conditioning, TEMPMATIC)

   Release and disconnect electrical connector (15).

9. Remove electrical wiring harness from front top crossmember with radiator unit (1) (arrows) and position wiring harness outside the working area.
10. Remove screws (21, 22, 23) .
11. Remove upper front crossmember with radiator unit (1).

    Helper required.

    Ensure correct seating of the seal on the upper front crossmember with radiator unit (1).

12. Install in the reverse order.