LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2021 >> Sprinter 1500 Van Cargo >> Repair and Diagnosis >> Body & Frame >> Frames, Subframes & Crossmembers >> Detachable Body Components - Description & Operation, Basic Knowledge, Safety Precautions, Testing & Repair, Retrofitting & Conversion >> Testing & Repair >> Remove/Install Complete Outside Mirror - Ar88.70-D-9000TS

Remove/Install Complete Outside Mirror - Ar88.70-D-9000TS

Model 907 

G13792952

Shown on model 907.6 with code JB6 (Parking Package with 360° camera), code F64 (electrically folding outside mirror), and code F68 (electrically adjustable and heated outside mirror) on the left side of the vehicle 

Shown on model 907.6 with code JB6 (Parking Package with 360° camera), code F64 (electrically folding outside mirror), and code F68 (electrically adjustable and heated outside mirror) on removed boot bracket (8) and boot (7), left side of the vehicle 

G13792953
WARNING Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. No parts of the body or limbs should be within the operating area when the components are moving. AS00.00-Z-0011-01A
  Information on preventing damage to electronic components due to electrostatic discharge   AH54.00-P-0001-01A
REMOVINGINSTALLING Remove/install     
1 Fully open respective side window    
2 Remove respective door trim (4) from the front door   AR72.10-D-6575TS
3 Remove boot (7) and boot bracket (8) Model 907.6/7
with code JB6 (Parking package with 360-degree camera)
SPECIAL TOOL Long wedge
Fig 1
4 Disconnect electrical connector from electrical line (3) Model 907.6/7
with code JB6 (Parking package with 360-degree camera)
IMPORTANT To do this, pull electric line (3) and electrical connector out of A-pillar.
IMPORTANT Secure electric line (3) against slipping back into A-pillar.
 
5 Disconnect electrical connections (5)    
6 Remove seal (6) INSTALLATION IMPORTANT : Check seal (6) for damage.
Depending on findings

Replace damaged seal (6).
 
7 Unclip subharness from outside mirror (1) SPECIAL TOOL Clip remover Fig 2
8 Remove outside mirror (1) NOTES
Secure outside mirror (1) against falling down.
This prevents damage to the outside mirror (1).
IMPORTANT For this purpose, unscrew screws (2).
TORQUE SPECIFICATION Bolt, outside mirror to front door
*BA88.70-N-1001-01TS 
9 Install in the reverse order    
  Calibrate     
10
REFER TO SELF-DIAGNOSTIC SYSTEMS
Calibrate 360° camera with diagnostic system Connect/disconnect diagnostic unit Model 907
with code JB6 (Parking package with 360-degree camera)
AD00.00-D-2000-06TS
INSPECT Check     
11 Carry out function check of the electrical functions of the outside mirror (1) IMPORTANT The extent of electrical functions varies depending on the vehicle equipment.  
EXTERIOR REARVIEW MIRRORS

Number Designation Model 907
BA88.70-N-1001-01TS Bolt, outside mirror to front door Nm 9
Fig 1: Long Wedge (115 589 03 59 00)
G13792954
Fig 2: Clip Remover (452 589 01 63 00)
G13792955