Remove/install camshaft Hall sensor - AR15.10-P-2000MR
ENGINE 274 in MODEL 172, 204, 207
| Remove/install | |||
| 1 | Remove upper engine cover | ||
| 2 | Disconnect electrical connector for respective camshaft Hall sensor (B6/15, B6/16) | ||
| 3 | Remove screw/bolt (1) for respective Hall sensor (B6/15, B6/16) | *BA15.10-P-1002-03I | |
| 4 | Pull out respective Hall sensor (B6/15, B6/16) | ||
| 5 | Install in the reverse order | ||
| 6 | Read out fault memory using the diagnostic system and clear if necessary | ||
| AD00.00-P-2000-04A | |||
| Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | AS00.00-Z-0005-01A | |
| 7 | Perform an engine test run; in doing so check engine for proper operation and leaktightness |
POSITION SENSOR
| Number | Designation | Engine 274 | |
|---|---|---|---|
| BA15.10-P-1002-03I | Screw/bolt, camshaft position sensor to cylinder head cover | Nm | 8 |