LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2006 >> SL65 >> Repair and Diagnosis >> General Information >> Reset Procedures >> ATEQ TPMS Reset Procedure >> ATEQ TPMS Reset Procedure >> Up To 5/30/04

Up To 5/30/04

  1. Turn ignition switch to OFF position.
  2. Ensure inflation pressure of all 4 tires is as specified on tire placard.
  3. Turn ignition switch to ON position. The standard display menu will appear in left and right multifunction displays on instrument cluster. See Fig 1.
  4. Using up or down arrow button (located on left side of multifunction steering wheel), select tire pressure monitor. In bottom center of instrument cluster, press instrument illumination rheostat and reset button.
  5. Press "+" button (located on right side of multifunction steering wheel). The multifunction display will now display as shown for about 2 seconds. See Fig 2.
    NOTE: Using any other button operations on multifunction steering wheel will terminate activation process.
  6. The multifunction display will now display a confirmation screen. See Fig 3.
  7. Once engine has started, the pressure value will be displayed immediately without numerical values (---).
    NOTE: If activation is carried out when engine is running, this display will be shown after a time delay of about 30 seconds.
  8. Drive vehicle for about 10 minutes. Current tire pressure will be displayed, and activation process is complete. See Fig 1.
Fig 1: Identifying TPMS Normal Display Message
G00225509Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Fig 2: Identifying TPMS Selection Screen Message
G00225507Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Fig 3: Identifying TPMS Reactivation Message (Up To 5/30/04 - Typical)
G00225508Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
scientia non olet · About LEMON Manuals